NID, Incorporated
  • HOME
  • ATOMIZERS
  • CMS KIT
  • HL KIT
  • MOTORS
  • RAF DATA
  • GALLERY
  • CONTACT US

Blender Headerliner Kit

This affordable and simple-to-install headerliner kit allows for the permanent modification of
the standard 6” and 8” round header pipe inside the blender drum.


Constructed of pre-formed 1/8” HMW Polyethylene, (same as blender wall liner material) it wraps around the pipe and
greatly helps the header:
  • shed flakes that tend to pile on top of the pipe and create surges in the flow of material throughput.
  • resist resin build-up and clean easier.
Picture
Pre-formed “teepee” design wraps around 4” angle iron and helps shed flakes that tend to
“bird nest” on top of header pipe and create
surging.

Note: Angle iron is not provided with kit and must be installed (stitch welded to header pipe) prior to installation of headerliner kit.
Picture
Headerliner Kit includes:
8’ sections of 1/8” Polyethylene HMW for entire
length of header pipe.

All mounting hardware, including self-threading
screws, 5 collared drill bits,
5 quick release clamps, alignment bracket, saddle template and detailed installation instructions.

Picture
Self-threading screws secure the seam on the bottom of the pipe. Special collared drill bits
prevent drilling all the way through the pipe where hoses and wiring are located.
Picture
Headerliner Kits
available for:


6” pipe X 25’  
Part No. HLK– 801

6” pipe X 30’  
Part No. HLK– 802

8” pipe X 25’  
Part No. HLK– 803

8” pipe X 30’  
Part No. HLK– 804

© 2021 NID, Inc. All Rights Reserved.  |  1552 Carr Lake Rd. SE Bemidji, MN 56601 | 218-755-1000  |  Website by Creative Pear Graphic Design LLC